Dental floss is extremely strong for its size.īefore you do this step, did you thread the pull-cord through the proper holes to the outside of this machine? I threaded the dental floss through the holes and pulled the cord through. I grabbed some dental floss and tied it to the pull-cord. I couldn't easily thread the pull-cord through the holes. I use a lighter to melt the end of the cord together. It frays very easily.Ī bit hard to see here. Use the cut cord to size your new pull cord to the proper length. When you do, the cable tie will hold the reel in place. Now the reel spring is properly tensioned. Then I put a cable tie through the spokes of the wheel attaching it to the reel casing. I PULLED THE CORD OUT TO ITS FULL LENGTH AS IF I STARTED IT. I put the reel back into the installed position. ![]() You can see the cord is held in with one simple knot. The pull-cord metal casing and reel are now free to remove. My guess is Toro omitted this screw for this very reason. I would not have been able to get the bottom screw without disassembling the bottom shell if that #4 screw were present. The pull-cord housing in mine was only held on by 3 screws (fortunately). Toro Powerlite Snow Thrower Blower Pull-Cord Replacement / Belt Repair - ContinuedĪt this point you've discovered the wheel bracket and motor support are one and the same because the whole machine collapsed when you removed the bolts supporting the wheel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |